I have recently noticed that when our Philips 200 FEG is set on PEELS mode, although the initial accerelating voltage is reduced to 195KeV (as expected ) at the startup of the session, at an unknown later point during operation it frequently reverts back to 200KeV. Many thanks to all of you that have kindly provided useful views/opinions regarding my previous enquiry on the GIF200. Hoping the someone out there can help (the half-hourly compressor All sealsĪnd gaskets have been replaced in all five valves with manufacturer's
The oblong box (manifold?) that the valves are mounted on. The symptom is a constant leak of air from the exhaust aperture of I don't know if the order mattersīecause the valves seem to be identical. This is a logical sequence but the other bank (which I have never SV1 (nearest sidewall of console), SV4, SV7, SV8 and SV22 (nearest It is the bank furthest from the rear of the microscope, the order I Have had these out several times, looking for an air leak and may have Pneumatic valves in the back of the main console of a 200CX TEM. I need to establish the installation arrangement of one bank of
Many thanks for your input on this topic.
#Asu mail code 9908 manual
Has anyone, drafted, a user manual, that relies on its experience and application on the particulat system? Will you be willing to share your operation manual with us?
#Asu mail code 9908 manuals
Has anyone in the past attempted to follow this path?Ĭ) The gatan operating manuals are judjed by many users, especially the Digital Micrograph manual, as not particularly helpful. It is my understanding that current Macs are PCI based, while ours have the DMA interface module fitted on a non PCI slot.
#Asu mail code 9908 upgrade
Any idea about the costs?ī)Will it be a worthy exerscise to upgrade at the same time the Macintoshes as well?. Will it be advisable to upgrade to Digital Micrograph 3.0 or not and why. In particular, I have the following questions Ī)The Current functional version of Digital Micrograph is 3.0 (as far as I know version 3.3.1 was just released and is yet untried ). We would like to hear from anyone that has gone that route already and gain from his exprerience/problems that has encountered. Therefore, in order to facilitate user usage, the question of upgrading arises. The current version of Digital Micrograph software installed on our Macs is 2.5.4.ĭuring operation, it is not unusual to observe several software glitches with the current configuration. The operating system on the Macs is MaCos 7.5.1 and the memory installed on the primary Mac ( Digital Micrograph, EL/P) is 49MB. Our Gif was purchased in 1995,and is fitted to a Philips TEM CM 200 FEG and is controlled by two Macintosh (nu-bus slots, 601 processors ) computers. Trying to optimise our GIF 200 System, we have encountered a number of problems, therefore we would appreciate any input on the topic. Contents Retrieved from Microscopy Listserver Archives
0 kommentar(er)
